Reloop Contour Controller Edition Manual de instrucciones descargar pdf (Pagina 24)





4. Now select the button „Add...“ followed by „Import“.

In the selection screen open the mapping le that is on the CD or that was downloaded from the

Reloop support site.



Should a problem arise and Contour‘s LEDs are not lit correctly, then this is probably caused in

most cases by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, etc.)

In order to solve the problem proceed as follows:

1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the upper right

corner.

2. Open the category „Controller Manager“.

3. For the following device entries the following port assignments have to be congured:

If several Contour devices are in use, the various in- and out-ports for the different channels have

to be divided among the devices.

Example: For 2 Contours the device entries should be manipulated as follows:

  

Contour V* (CH1) Reloop CONTOUR Reloop CONTOUR

Contour V* (CH2) Reloop CONTOUR Reloop CONTOUR

Contour V* (CH3) Reloop CONTOUR Reloop CONTOUR

Contour V* (CH4) Reloop CONTOUR Reloop CONTOUR

Contour V* (Master) All ports None

  

Contour V* (CH1) Reloop CONTOUR Reloop CONTOUR

Contour V* (CH2) Reloop CONTOUR2 Reloop CONTOUR2

Contour V* (CH3) Reloop CONTOUR Reloop CONTOUR

Contour V* (CH4) Reloop CONTOUR2 Reloop CONTOUR2

Contour V* (Master) All ports None

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

Sin comentarios

Reloop Contour Controller Edition Manual de instrucciones Pagina 24